KDT Edgebanding Machine Guillotine Blades 110x20x13mm Edgebannder Cutting Knives

When the guillotine on a KDT edgebander starts leaving a rough cut or a torn edge on the banding, the blade edge is the first thing to check. A worn or chipped blade affects the cut on every panel that runs through the machine. Replacing it with the correct guillotine blade restores a clean cut at the guillotine station.

The guillotine blade is a cutting tool for KDT edgebanders. It comes in three sizes: 100x82x7mm, 106x82x7mm, and 110*20*13mm. Blades are available in positive and reverse directions. To confirm the fit, compare your machine's blade dimensions against these sizes and check which direction your machine requires.

Before mounting, check the blade seat and the direction marking on the machine. A positive or reverse blade must match the machine's setup. When the blade is seated correctly, the guillotine cuts the banding cleanly and the cut edge stays consistent from panel to panel.

Blades are supplied as individual cutting tools; packing and customisation are not stated. When you enquire, send the KDT machine model, the required size from the three sizes, and the direction needed. Contact us for product details. Supply comes from the same range as the rest of the catalogue.

What the specification fixes, and what it leaves to the machine:

• Guillotine cutting station — Fits the guillotine cutting station on KDT edgebanders, where the blade trims the edgebanding material after it is applied to the panel.
• KDT machine fit — Made for KDT edgebanders, so the blade mounts at the guillotine position on that machine family rather than a generic holder.
• Three size options — Available in 100x82x7mm, 106x82x7mm, and 110*20*13mm, giving three dimension choices to match the blade seat on your machine.
• Positive direction — Positive direction blades are available for machines set up to run that blade orientation at the guillotine cutting position.
• Reverse direction — Reverse direction blades are also available, so buyers can match the direction their KDT edgebander requires at the cutting station.
• Edgebanding cut quality — The blade cuts edgebanding material at the guillotine, and a sharp edge keeps the cut face clean on each banding strip.
• Wear point at cutting edge — The cutting edge is the wear point; when it dulls or chips, the cut on the banding changes and the blade needs replacement.
• Blade thickness check — Thickness is 7mm on the 100x82x7mm and 106x82x7mm sizes and 13mm on the 110*20*13mm size, so check the seat clearance.

What changes on the shop floor when the right part goes back in:

• Restores a clean guillotine cut. A fresh blade at the guillotine station cuts the banding cleanly again, so panels leave the machine without the rough edge that a worn blade leaves behind.
• Three sizes cover more machines. With 100x82x7mm, 106x82x7mm, and 110*20*13mm available, buyers can match the blade seat dimensions instead of forcing one size onto every KDT setup.
• Direction options reduce wrong-fit risk. Positive and reverse blades are both available, so the blade can be ordered to match the direction your KDT edgebander requires at the cutting position.
• Simple wear-part replacement. The blade is a wear part at the cutting edge; keeping the correct size and direction on hand means a dull blade can be swapped without changing the machine setup.
• Fit confirmed before ordering. Comparing your machine's blade dimensions against the three sizes and checking direction lets you confirm the fit before the order is placed.
• Clear enquiry process. Send the KDT machine model, the size from the three options, and the direction needed, and the enquiry can be matched to the blade you require.
• Consistent cut across the run. A correctly seated guillotine blade cuts each banding strip the same way, so the cut edge stays consistent from the first panel to the last.